Scantool 5 USB ElmScan Manual do Utilizador descarregar pdf

1. Install drivers 2. Connect scan tool to the PC 5. Identify the COM port

Insert the software CD in your CD-ROM drive. Connect ElmScan 5 USB to your PC's USB port Click the “STN Finder” link:

The scan tool selection menu will automatically using the USB cable (steps & ).

appear. Click on the icon labeled "ElmScan 5

USB":

3. Locate the diagnostic connector

The STN Finder dialog will appear. Click “Start”

and record the COM port number and baud rate

where a scan tool is found:

The software selection menu will appear. Click on

the driver link for your operating system and

follow the prompts to install the drivers:

4. Connect scan tool to the DLC

Turn the vehicle’s ignition to the Key On Engine

Off position. Follow connection diagram (directly

below) to connect ElmScan 5 USB to the diag-

nostic connector using the OBD-II cable (steps

& ).

If the menu does not appear, click “Start g

Run”, type D:\setup.exe (where D is the drive

letter of your CD-ROM drive), and click OK.

With step completed, watch the LEDs as you

are performing step . The "POWER” LED will

change from red to yellow and the Tx/Rx LEDs

will cycle on and off from left to right .

A B

The 16-pin D-shaped diagnostic link connector

(DLC) should be located in the passenger or

driver's compartment in the area bounded by the

driver's end of the instrument panel to 300 mm

(~1 ft) beyond the vehicle centerline, attached to

the instrument panel and easy to access from the

driver's seat. The preferred location is between

the steering column and the vehicle centerline.

ElmScan Quick Start USB 5

ES5UQSG20090812

OBD

POWER

Tx Rx Tx Rx

POWER

Tx Rx Tx Rx

USB

vehicle

OBD-II cable

USB cable

computer

scan tool

Continued on reverse side

1 2

Resumo do Conteúdo

Página 1 - ElmScan Quick Start USB 5

1. Install drivers 2. Connect scan tool to the PC 5. Identify the COM portInsert the software CD in your CD-ROM drive. Connect ElmScan 5 USB t

Página 2 - Troubleshooting

The Device Manager will appear. Under this view, After changing the COM port, launch ScanTool.net 6. Install ScanTool.net softwareexpand “Port

Comentários a estes Manuais

Sem comentários

Scantool 5 USB ElmScan Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Acessórios para Computador Scantool 5 USB ElmScan. ScanTool 5 USB ElmScan User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios para Computador Scantool 5 USB ElmScan